Table of Contents
Advertisement
DIGITAL IMAGE RECORDER
2
Q & A
Question
- If power goes out during record
ing and comes in later, will the
system continue recording?
- What will become of the system if
it is disconnected with the input
video signal during recording?
- What shall I do if I forget all net
work access codes including
password and ID?
8-3
Answer
- Without power supply, the system does not begin
recording. However if the system was in recording
mode before power was out, the system will con
tinue recording upon power recovery.
- Once disconnected with the input video signal,
the system stops recording. But the system will
continue recording upon recovery of signal input.
- You shall reboot the system while you hold on the
FACTORY RESET in the back after system shut
down. Then, all the system setup values will be
initialized as they were before factory delivery.
http://www.securitysamsung.com
Advertisement
Table of Contents
