Table of Contents
Advertisement
DIGITAL IMAGE RECORDER
Recognition of Input Video Signal
In the event of no video signal when you turn the system on, VL(Video Loss) will
appear and the buzzer will sound.
Then, if you press the ALARM button, the buzzer will be off. If you set VIDEO
LOSS BUZZER to OFF in ALARM OUT/BUZZER SETUP menu, the buzzer will
sound by no means.
CAM 1
CAM 3
When HDD is Bad.
BAD
CAM 1
CAM 3
The
mark will appear on the top left corner in case of abnormal HDD opera-
BAD
tion.
3-3
2003-07-01 00:00:00
CAM 2
CAM 4
2003-07-01 00:00:00
CAM 2
CAM 4
Power Off
Click SYSTEM SHUTDOWN in the SYSTEM SETUP MENU to turn the power off.
Then, the following message will pop up.
DO YOU WANT SHUTDOWN?
YES
NO
If you click YES, the system will stop with the following message.
SYSTEM IS HALTED.
After the system stops normally, separate the power jack in the back of the system
from the main body.
No power switch is attached.
In case you turned off the system power during recording, recording will resume
upon the booting of the system after you turn the power on again.
Caution
Caution
After you turn the system power off, put an interval of 3 seconds until you turn the
power on again. Otherwise, the system may malfunction.
Factory Reset
1. Disconnect the system power.
2. Connect the system power while you hold on the factory reset button in the back of the system.
3. Keep pressing the factory reset button until the basic screen appears in the monitor.
Caution
Caution
Factory reset will initialize all setup values to be the basic ones for factory delivery.
3-4
Advertisement
Table of Contents
