Samsung SEF-54PZF User Manual page 49

5
Set the zoom position to suit the subject and
place the flash unit at the desired location.
6
Turn the flash unit on the camera on.
●If the camera's built-in flash unit is part of
the combination, pop up the built-in flash
unit.
7
Check that the ready lamp is lit, then take the
picture.
●When charging is complete, a lamp on the
flash unit on the camera and the ready lamp
on the SEF-54PZF will blink.
●Position the slave unit(s) so that the slave
sensor can receive the flash fired by the
camera' s built-in flash unit or attached flash
unit.
●The SEF-54PZF will fire at the same time that
the camera' s flash fires.
●Keep the distance from the built-in flash unit
and SEF-54PZF to the subject within 4
meters.
●The slave unit will turn off automatically
after about 1 hour of non-operation when the
auto power off function is set.
●Do not use red-eye reduction with the
camera' s flash. This will result in the SEF-
54PZF firing by the pre-flash. For the same
reason, set the camera to manual focus when
firing the flash continuously so that the AF
spotbeam does not operate with cameras
that have AF spotbeam functions.
49