Samsung SEF-54PZF User Manual page 41

⑦ When you turn the camera on and press
the shutter release button halfway down,
the channel of the flash unit is registered on
the camera.
(Preparation of Separated Flash Unit)
2
Next, set the channel of the separated (wire-
less) flash unit to the same channel as the
flash unit attached to the camera.
① Place the other SEF-54PZF in the desired
position.
② Set the power switch of the flash unit to
(WIRELESS).
③ Press the wireless mode button (M/C/S) the
number of times required to display SLAVE
on the LCD panel.
④ Slide down the setting switch to the (yellow
dot) to display the channel on the LCD panel.
⑤ Press the channel button (CH) and select
the same channel that the flash unit
attached to the camera has been set to.
⑥ Slide the setting switch back up to the
(white dot)
●The two flash units must be set to the same
channel, otherwise the separated flash unit
will not fire.
(Photographing)
3
Confirm that both flash units are fully charged,
and take the photograph.A lamp on the wire-
less flash unit will blink.
41