Table of Contents
Advertisement
⑥ Slide the setting switch back up to the (white dot).
⑦ When you turn the camera on and press
the shutter release button halfway down,
the channel is registered on the camera.
- Set the sync mode to the HS.
2
Next, set the channel of the separated (wireless)
flash unit to the same channel as the flash unit
attached to the camera.
① Place the other SEF-54PZF in the desired
position.
② Set the power switch of the flash unit to
(WIRELESS).
③ Press the wireless mode button (M/C/S) the
number of times required to display SLAVE
on the LCD panel.
④ Slide down the setting switch to the (yellow
dot) to display the channel on the LCD panel.
⑤ Press the channel button (CH) and select
the same channel that the flash unit
attached to the camera has been set to.
⑥ Slide the setting switch back up to the (white dot).
●The two flash units must be set to the same
channel, otherwise the separated flash unit
will not fire.
3
Set the sync mode switch of the wireless flash
unit to leading curtain sync (
4
Set the exposure mode of the camera to man-
ual exposure and the shutter speed to the
same or faster than X-sync speed.
●If the shutter speed is the same or slower
than the X-sync speed of the camera, the
flash will be set to P-TTL mode, and when it
is faster than Xsync speed, the flash will be
set to high-speed sync mode.
5
Confirm that both flash units are fully charged,
and take the photograph.
A lamp on the wireless flash unit will blink.
).
47
Advertisement
Table of Contents
