Table of Contents
Advertisement
Procedure
1
Turn on the power switch.
2
Press the flash mode button (MODE) until (A)
is displayed on the LCD panel.
3
Set the aperture value and ISO.
① Press the select button (S) so that (f/stop)
on the LCD panel blinks.
② Turn the adjustment dial to set the aperture
value.
●The effective flash range is displayed on the
LCD panel bar graph.
③ Confirm that the subject is within the effective
flash range and press the select button (S).
④ Turn the adjustment dial to set the ISO after
(ISO) starts blinking.
⑤ Press the select button (S). The setting is
complete if (ISO) stops blinking.
28
4
Set the lens aperture to the same aperture
value as that set on the LCD panel.
●The camera's aperture value is synchronized
with that of the flash unit when the camera
exposure mode is set to Programmed AE or
Shutter Priority AE.
5
Set the zoom position. (The setting method
differs according to your camera and lens.
Refer to page 23.)
●Select (M.Zoom) regardless of the type of
lens being used.
6
Confirm that the subject is within the effective
flash range and the ready lamp is lit. Then
take a picture.
●When the camera is turned off, the flash
mode is changed to the P-TTL mode.
To use the A zoom mode, select it again.
●The sync mode will be fixed in leading
curtain sync.
Advertisement
Table of Contents
