Table of Contents
Advertisement
⑦ When you turn the camera on and press
the shutter release button halfway down,
the channel is registered on the camera.
2
Next, remove the flash unit from the camera
and place it in the desired position.
●Press the flash mode button (MODE) to dis-
play (P-TTL) if the flash mode was set to the
modes other than P-TTL.
3
Set the zoom position. (Refer to page 23)
●Set the zoom position with (M.Zoom) regard-
less of the lens you use.
4
Enable the built-in flash unit of the camera and
display (
) on the LCD panel.
5
Set the sync mode switch of the wireless flash
unit to leading curtain sync (
6
Set the exposure mode of the camera to man-
ual exposure and the shutter speed to the
same or faster than X-sync speed.
●If the shutter speed is the same or slower
than the X-sync speed of the camera, the
flash will be set to P-TTL mode, and when it
is faster than Xsync speed, the flash will be
set to high-speed sync mode.
7
●The built-in flash unit is used for control
flash only. It will not be used for main flash.
●Refer to camera's operating manual for the
operation of the camera.
●Depending on the camera model, the built-in
flash combination feature may not be supported.
(GX-1L/1S, GX-10 and GX-20 do not support it.)
).
Confirm that the SEF-54PZF and built-in flash
unit are fully charged, and take the photo-
graph. A lamp on the wireless flash unit will
blink.
45
Advertisement
Table of Contents
