Table of Contents
Advertisement
1
Firstly, set the wireless mode and channel of
the SEF-54PZF and register them on the
camera.
① Turn the camera off and then attach the
SEF-54PZF to the hot shoe of the camera.
② Set the power switch of the flash unit to
(WIRELESS).
③ Press the wireless mode button (M/C/S) the
number of times required to display SLAVE
on the LCD panel.
●You cannot set the flash unit to SLAVE while
the exposure metering timer is on (while
information relating to aperture etc. is dis-
played in the viewfinder).
④ Slide down the setting switch to the (yellow
dot) to display the channel on the LCD
panel.
⑤ Press the channel button (CH) and select a
channel from 1CH to 4CH.
⑥ Slide the setting switch back up to the
(white dot).
⑦ When you turn the camera on and press
the shutter release button halfway down,
the channel is registered on the camera.
2
Next, remove the flash unit from the camera
and place it in the desired position.
●Press the flash mode button (MODE) to dis-
play (P-TTL) if the flash mode was set to the
modes other than P-TTL auto.
3
Enable the built-in flash unit of the camera and
set the camera flash mode to the wireless
mode (
).
4
Confirm that the SEF-54PZF and built-in flash
unit are fully charged, and take the photo-
graph. A lamp on the SEF-54PZF will blink.
●In the P-TTL mode, flash output setting (1/1,
2/3,1/2, and 1/3) and flash exposure compen
sation (-3.0 to +1.0) are possible.
●The flash mode on the camera must be set to
(WIRELESS), otherwise the SEF-54PZF
will not fire.
● By changing the camera's function settings,
you can set the built-in flash unit so that it is
not the main flash. Refer to the operating
manual for the camera to find out how.
● For test flash, refer to page 55.
39
Advertisement
Table of Contents
