Table of Contents
Advertisement
4.8.99
Operating several mobile units
Logging on Gigaset 2000S standard mobile unit at the base station
KAP12.FM4
You can operate the following at a Gigaset 2015 base
station: up to six Gigaset 2000S mobile units (standard
mobile units) and/or Gigaset 2000C mobile units (Comfort
mobile units) in addition to the Gigaset 1000TAE cordless
interface.
Each additional mobile unit must be "logged on" at the
base station.
If you wish to operate your mobile unit at sever-
al base stations (
the following procedure at each of these base
stations.
Make sure that the mobile unit is switched off
(
page 11).
?
Keep pressing the green paging key at the base station
until you hear the log-on (registration) tone (this takes
roughly 10 seconds).
B
o
Within the next minute: enter the required base station
number (1 to 4) and hold down the key. Then press also
B
key
until the display appears on the mobile unit.
Operation at one base station:
press
Operation at several base stations:
when logging on at the first base station, press
1
press
#
o
Enter the 4-digit system code (
All unassigned internal numbers are shown on the dis-
play of the mobile unit:
:
23456
N
P f
o
Enter one of the unassigned internal numbers. The mo-
bile unit is registered under the internal number entered.
Gigaset 2015, GBR: A30852-X-1105-B301-1-7619
Operating several mobile units
page 62), you must repeat
1
B
and also
.
B
and also
; at the second base station,
2
B
and also
, etc.
page 14) and then
(Example: 2,3,4,5 and 6
are still unassigned)
#
.
57
Advertisement
Table of Contents
