4.8.99
Operating several mobile units
Logging on Gigaset 2000C Comfort mobile unit at the base station
Setting trunk class of service for mobile unit
58
KAP12.FM4
If you wish to operate your mobile unit at sever-
al base stations (
the following procedure at each of these base
stations.
For menu prompting of the Gigaset 2000C Comfort mo-
bile unit, refer to
?
Keep pressing the green paging key at the base station
until you hear the log-on (registration) tone (this takes
roughly 10 seconds).
Carry out the following procedures within the next
minute:
.
Call down the menu.
Settings
Scroll to
Confirm, then scroll to
Confirm, then scroll to the required base station number.
Operation at one base station:
select
Operation at several base stations:
when logging on at the first base station, select
Station 1
Station 2
OK
Confirm the selected base station; the mobile unit
searches for the base station.
o
Enter the 4-digit system code (
OK
Confirm log-on (registration). The unassigned internal
numbers are shown on the display of the mobile unit.
o
Enter one of the unassigned internal numbers. The mo-
bile unit is registered under the internal number entered.
You can specify whether or not the mobile unit(s) can set
up external calls. A distinction is made between:
direct exchange access (default setting) – outgoing
external calls can be made
indirect exchange access – outgoing external calls
cannot be made, but incoming external calls can be
taken.
Gigaset 2015, GBR: A30852-X-1105-B301-1-7619
page 62), you must repeat
page 68.
Log on
Station 1
; at the second base station, select
, and so on.
page 14).