Table of Contents
Advertisement
4.8.99
Important information on setup and operation
Important information on setup and operation
Notes on setting up the base station
Notes on use of the batteries
4
kap03.fm4
You should take the following points into account when
deciding where to install the base station:
There must be a 220V/230V power socket in the vi-
cinity.
The base station should not be located in the imme-
diate vicinity of other electronic devices, such as a hi-
fi system, a microwave oven or office equipment,
otherwise there is a risk of mutual interference.
The base station is designed for operation in protect-
ed rooms with a temperature range from +5°C to
+45°C. For example, it should not be set up in a
bathroom, laundry room or damp basement or
directly adjacent to sources of heat, such as radiators.
Direct sunlight must also be avoided.
Place the base station on a level, non-slip surface.
The device feet do not normally leave any unsightly
marks. However, in view of the many different var-
nishes and polishes currently used for furniture, the
possibility of telephone components leaving marks
on the mounting surface cannot be entirely ruled out.
Radio communication between the base station and
the mobile units is based on the Digital Enhanced
Cordless Telecommunications (DECT) standard. If
you have any problems with radio transmission,
please get in touch with your dealer.
Depending on the ambient conditions, the maximum
radio range between the base station and the mobile
units is approx. 300 metres out of doors and approx.
50 metres indoors. If the range warning tone has
been activated at the mobile unit (
will receive an audible signal when you go out of
range.
Important information concerning the use of batteries:
The mobile unit is supplied with two rechargeable
nickel-cadmium batteries in AA format.
Use the supplied batteries only.
Gigaset 2015, GBR: A30852-X-1105-B301-1-7619
page 39), you
Advertisement
Table of Contents
