Cpu Installation; Cpu Speed Setting; Memory Installation - MATSONIC MS6380SG User Manual

8

CPU Installation

CPU Speed Setting

This mainboard provides CPU Plug and Play technology,
so that there is no need to do the CPU jumper setting.
Enter the BIOS Setup and select "CPU Plug and Play
Setup". Choose the correct CPU speed to match your
CPU installed.
However, if you need to change a CPU, follow the below
steps:
1. Power off system and unplug the power core.
2. Install a new CPU to Socket7.
3. Clear CMOS RAM (see Jumper Settings) or hold
down the <Insert> key then power on the system.
4. After power on the system, then enter the BIOS
Setup section to set the new CPU speed.
Note: If the CPU speed is set incorrectly and fails to boot up
the system, then repeat steps 1, 3, 4 again.

Memory Installation

The mainboard lets you add up to 768MB of system
memory through 3 DIMM sockets on the board, that is
divided into 3 banks: Bank 0, Bank 1, and Bank 2, which
supports the following memory configurations.
Bank Memory Module
Bank 0
DIMM1 4MB, 8MB, 16MB, 32MB, 64MB, 128MB, 256MB
Bank 1
DIMM2 4MB, 8MB, 16MB, 32MB, 64MB, 128MB, 256MB
Bank 2
DIMM3 4MB, 8MB, 16MB, 32MB, 64MB, 128MB, 256MB
Total System Memory = Bank 0 + Bank 1 + Bank 2
Notes: 1. Supports only 3.3V SDRAM DIMM modules.
2. The SDRAM must be installed in DIMM1 first, if onboard
VGA is being used.
Chapter 2