Advanced Connection; Connecting The Remote Control Jacks - Marantz PM6003 User Manual

ENGLISH

ADVANCED CONNECTION

CONNECTING THE REMOTE CONTROL JACKS

INPUT
IN OUT
REMOTE CONTROL
CD player
q
You can control other Marantz products through this
unit with the remote controller by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote controller
is received by the remote sensor on this unit. Then
the signal is sent to the connected device through
this terminal. Therefore you need to aim the remote
signal only to the unit.
Set the REMOTE CONTROL SWITCH on the back of
other units (not the PM6003) to "EXT".(EXTERNAL)
to use this feature.
10
q w
OUTPUT
RC OUT
OPTION
w
Whenever external infrared sensors or similar
devices are connected to Remote Control IN of
the unit, be sure to always disable operation of the
infrared sensor on the unit by using the following
procedure.
REMOTE CONTROL SETTINGS
PHONO PHONO
INPUT SELECTOR INPUT SELECTOR
SOURCE DIRECT SOURCE DIRECT
BASS BASS
STANDBY STANDBY
POWER ON/OFF POWER ON/OFF
PHONES PHONES
SPEAKERS A/B button
1.
Press and hold the SPEAKER B button on the front panel more than 5 seconds.
2.
Front remote sensor is disabled and MUTE indicator blink 3 times.
Note
• Be sure to set remote sensor enable when external infrared sensors or similar devises are not connected.
• Otherwise the unit will be unable to receive remote control commands.
3.
To restore the original setting, press and hold SPEAKER A button on the front panel more than
5 seconds.
4.
Front remote sensor is enabled and RECORDER 2 indicator blink 3 times.
TUNER TUNER CD CD AUX/DVD AUX/DVD 1 1 RECORDER RECORDER 2 2 MUTE MUTE
VOLUME VOLUME
A A SPEAKERS SPEAKERS B B LOUDNESS LOUDNESS
TREBLE TREBLE BALANCE BALANCE
MIN MIN MAX MAX
L L R R