Advanced Connection; Connecting The Remote Control Jacks - Marantz PM5003 User Manual

ENGLISH

ADVANCED CONNECTION

CONNECTING THE REMOTE CONTROL JACKS

SPEAKER SYSTEMS SPEAKER SYSTEMS
CLASS 2 WIRING CLASS 2 WIRING
SYSTEM A SYSTEM A
R L
RECORDER 2
(MD / TAPE)
L
R
R L
OUT
N
SYSTEM B SYSTEM B
INPUT
IN
OUT
REMOTE CONTROL
CD player
q
You can control other Marantz products through this
unit with the remote controller by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote controller
is received by the remote sensor on this unit. Then
the signal is sent to the connected device through
this terminal. Therefore you need to aim the remote
signal only to the unit.
Set the REMOTE CONTROL SWITCH on the back of
other units (not the PM5003) to "EXT".(EXTERNAL)
to use this feature.
10
SWITCHED SWITCHED
120W 1A MAX 120W 1A MAX
FLASHER FLASHER REMOTE REMOTE
IN IN CONTROL CONTROL
IN IN
OUT OUT
UNSWITCHED UNSWITCHED
120W 1A MAX 120W 1A MAX
AC OUTLETS AC OUTLETS
120V 120V 60Hz 60Hz
q w
OUTPUT
EXTERNAL INTERNAL
- +
w
Whenever external infrared sensors or similar
devices are connected to Remote Control IN of
the unit, be sure to always disable operation of the
infrared sensor on the unit by using the following
procedure.
7 Remote control settings
AC IN AC IN
1.
Press and hold the SPEAKER B button on the
front panel more than 5 seconds.
2.
Front remote sensor is disabled and MUTE
indicator blink 3 times.
NOTES:
• Be sure to set remote sensor enable when
external infrared sensors or similar devises are
not connected.
• Otherwise the unit will be unable to receive
remote control commands.
RC OUT
OPTION
INTEGRATED AMPLIFIER PM5003 INTEGRATED AMPLIFIER PM5003
PHONO PHONO TUNER TUNER CD CD AUX/DVD AUX/DVD 1 1 RECORDER RECORDER 2 2 MUTE MUTE
INPUT SELECTOR INPUT SELECTOR VOLUME VOLUME
SOURCE DIRECT SOURCE DIRECT A A SPEAKERS SPEAKERS B B LOUDNESS LOUDNESS
BASS BASS TREBLE TREBLE BALANCE BALANCE
STANDBY STANDBY MIN MIN
POWER ON/OFF POWER ON/OFF
PHONES PHONES
L L R R
SPEAKERS A/B button
3.
To restore the original setting, press and hold
SPEAKER A button on the front panel more
than 5 seconds.
4.
Front remote sensor is enabled and RECORDER
2 indicator blink 3 times.
MAX MAX