Connection Of Speaker Systems; Connection Of Ac Power Cable - Marantz PM6003 User Manual

ENGLISH
BASIC CONNECTIONS

CONNECTION OF SPEAKER SYSTEMS

This unit is equipped with two sets of SPEAKER SYSTEM terminals––SYSTEM A terminals and SYSTEM B
terminals. Usually connect your speaker system to the SYSTEM A terminals.
• The speakers in the speaker system should have an impedance between 8 and 16 ohms. If speakers with
an impedance of less than 8 ohms are connected, the protection circuitry may be activated during play.
• Connect the Right channel speaker to the R terminals, and the Left channel speaker to the L terminals.
• The output terminals have positive (+: Red) and negative
(–: Black) polarity, and each speaker also has the same polarity (+ and –). When connecting the speaker,
be sure to connect the terminals with the same polarity (+ with +, – with –).
• When connecting just one speaker set, you can obtain better sounds quality by connecting to SYSTEM
A.
8
WIRING SPEAKER CABLE
• Be careful not to short circuit in wiring speaker
cables.
• Peel off the corting of speaker cable as shown
below.
Approx. 1 cm
Cut the Peel off the Twist
corting of edge of cable. conductors.
cable.
• Wiring with speaker cable.
Turn counter- Insert Turn
clockwise to conductor of clockwise to
loosen. cable. tighten.
Your speaker system must satisfy the below
conditions. If it does not, the PM6003's protective
circuit will active, whereby preventing proper
playback. In some cases, the amplifi er and speakers
may be damaged.
• If using 1 set of speakers, total speaker impedance
must be 4 ohms or more.
• If using 2 sets of speakers, total speaker
impedance must be 8 ohms or more.
CONNECTION OF AC
POWER CABLE
1.
Plug the power cable into AC IN jack on the
back panel.
2.
Turn on the power switch of the audio unit
(amplifi er, etc.) that is connected with this
unit. Set the selector on the connected unit
to this unit.
3.
Plug the power cable into an AC outlet.