Dvd Audio/Multi Channel In Playback - Pioneer VSA-AX10I-S Operating Instructions Manual

DVD Audio/MULTI CHANNEL IN Playback

There are two types of MULTI CH IN modes: DIRECT and ADJUST. In the latter you can add sound features and
in the former these are fixed. To select these two settings (as well as OFF) follow the procedure below:
Amplifier
LISTENING MODE
SURROUND
STEREO
THX STANDARD
/DIRECT
ADVANCED ADVANCED
CINEMA CONCERT
DIGITAL
MIDNIGHT
NR
1
memo
• OFF does not display when MULTI CH IN is cancelled. The listening mode only is displayed, such as
"ACTION."
• You can't select listening modes for MULTI CH IN. Selecting a listening mode cancels the MULTI CH
IN.
• In DIRECT mode, if the center speaker is set to "NO" the signal for that channel is divided between
the front speakers. If any other speakers are set to "NO" the signal for that (those) channel(s) won't
get output at all.
• If the amplifier is in DIRECT mode, and you set sound features (p.58-60) on (excluding sound delay),
the mode will change to ADJUST automatically.
See MULTI CH IN SELECT (p.93) for more on MULTI CH IN
playback.
MAIN
MAIN SUB
(DVD-A
/SACD)
1
MULTI CH
IN
2
LISTENING
CH SEL.
ACOUSTIC
CAL.
2
1 Press MULTI CH IN button on the
remote control's AMP MAIN screen.
Use the button to cycle through the
different multi channel in modes.
DIRECT: This is a true playback of the signal from the
MULTI CH INPUT terminals, output without digital
processing. You can only control each channel level.
ADJUST: This setting allows three types of control
over the sound output: You can: 1) control each
channel level individually; 2) apply the settings in
SURROUND SETUP (p.40-48) and 3) apply different
sound features (p.58-60).
OFF (Normal display): Cancels the MULTI CH IN
modes.
2 Use the LISTENING CH SEL button to
select the number of input channels.
You can select 2 or 8 channels. For best sound quality
use 2 channels when you listen to stereo sources.
Basic Operation
61
En