Table of Contents
Advertisement
[
|
| OPERATIONS
Switch numbers used in the following explanations refer to the
numbers appearing in the illustration on page 4.
BEFORE BEGINNING OPERATIONS
_ COPYING TAPES
1. Turn VOLUME CONTROL knob fully to the left, to the
"O"" position.
2. Switch POWER on.
| PLAYBACK PROCEDURES
1. Set INPUT
SELECTOR
switch
@ to the desired
playback source.
® For playback with the equipment connected to LINE terminais:
Set to [LINE].
® For reception of an AM/FM broadcast: Set to [TUNER].
® For playback of a record: Set to [PHONO].
© For playback of a compact disc: Set to [CD].
© For playback of a tape: Set to [DAT/TAPE
1] or [TAPE 2].
2. Operate the equipment to begin playback.
3. Adjust playback volume with VOLUME CONTROL @)
on this unit.
RECORDING TAPES
1. Select the recording equipment with REC SELECTOR
switch @).
® When set to SOURCE, the signals from the device connected to
the terminals of the selected input are recorded. (To record signals
from the device connected to PHONO or LINE terminals, for
instance set REC SELECTOR switch to SOURCE and set INPUT
SELECTOR switch to PHONO or LINE accordingly.)
® Recording is impossible when the switch is set to OFF.
NOTE:
In any position other than SOURCE and OFF, the source selected with
the REC SELECTOR switch is recorded regardless of the position of the
INPUT SELECTOR switch.
When the switch is in the SOURCE position, the signal of the component
selected with the INPUT SELECTOR switch is recorded.
When not
recording, switching to the OFF position prevents any loss in sound
quality.
2. Begin recording by operating the recording equipment.
Refer to the operating instructions for your cassette deck for proper
operating procedures.
| MONITOR WHILE OPERATING
On a 3-head cassette deck, sound can be concurrently heard recording
on cassette. This operation of checking the sound quality and recording
level is called ''monitoring.'" For monitoring, INPUT SELECTOR switch
of this unit must be set to the cassette deck on which recording is being
done.
° When recording with the cassette deck connected to DAT/TAPE
1
terminals: Set to DAT/TAPE 1.
¢ When recording with the cassette deck connected to TAPE 2
terminals: Set to TAPE 2.
NOTE:
When recording from PHONO or LINE source, recording monitor is not
possible.
6
<ARB1391>
When two decks are used (or when using double cassette deck), you
can record the sounds from one deck onto the other.
Application examples:
* To make 4 tape copy with contents identical to the original tape.
* To edit a recording of an FM broadcast in order to cut out unwanted
commercials, recording only desired material onto another tape.
When using two cassette decks
1. Load tapes for playback
(pre-recorded tape) and
recording (blank tape) into the respective cassette
decks.
2. Select the copying direction with REC SELECTOR
switch @.
¢ When copying from the cassette deck of DAT/TAPE 1 terminals
to the cassette deck of TAPE 2 terminals: Set to TAPE 1 B 2.
© When copying from the cassette deck of TAPE 2 terminals to the
cassette deck of DAT/TAPE 1 terminals: Set to TAPE 2 B 1.
NOTE:
The tape input selected with REC SELECTOR switch can be copied,
regardless of the settings of INPUT SELECTOR.
3. Operate the cassette decks to begin copying.
Set the cassette deck with the bland tape to the recording mode,
and set the cassette deck with the original (playback) tape to the
playback mode.
Advertisement
Table of Contents
