Multi Ch In Select - Pioneer VSA-AX10I-S Operating Instructions Manual

MULTI CH IN SELECT

Use this feature to adjust the type of output for audio signals which were input from MULTI CH INPUT
terminals. You can set the output of the audio signal in regards to the surround speakers and the surround
back speakers, which were input from 5.1 channel surround sound soundtrack.
There are three OUTPUT MODE settings:
THROUGH: the sound is output directly how it was input.
S =SB: The audio signal which was input into the surround channels will be output from the surround
back speakers only.
S=S & SB: The audio signal which was input into the surround channel is output from the surround
speakers and from the surround back speakers. This setting will give the most realistic home theater
experience in the MULTI CH IN SELECT setting if you don't connect surround back inputs.
ENTER
5˜∞˜2˜3˜ENTER buttons
1
3.Expert Setup
[1. OSD Adjustment ]
[2. Bass Peak Level ]
[3. D-Range Control ]
[4. Multi-Ch In Select
[5. Function Rename ]
[6. Hi-bit/Hi-sampling ]
[Return]
2
3.4. Multi-Ch In Select
Surround Back Input
[Yesx2]
Output Mode
[Through]
[Return]
3,
3.4. Multi-Ch In Select
4,5
Surround Back Input
[Yesx2]
Output Mode
[
[Return]
• If you want to setup either S=SB,
memo
S=S & SB, you need to connect
all 7.1 CH speakers, including the
surround back left and right speak-
ers.
• If you use only one surround back
speaker hook it up to the left sur-
round back speaker terminal.
Follow steps 1-4 on page 89, if necessary, to get to the
starting point mentioned here.
STANDBY/ON
1 MULTI-CH IN SELECT should be
2 Use the 2 3 buttons to select surround
]
3 Use the 5∞ buttons to select the
4 Use the 2 3 buttons to choose a type
5 Use the 5∞ buttons to select RETURN.
S SB ]
6 If you want to continue EXPERT SETUP
7 If you want to finish EXPERT SETUP
selected if it isn't use the 5∞ buttons
to select it. Press ENTER.
back input: YESx2, YESx1 or NO
You do this to establish the proper downmixing of sur-
round back channels. If you connected two surround back
inputs choose YESx2. If you connected one surround back
input choose YESx1. And if you connected no surround
back inputs choose NO.
OUTPUT MODE you want.
See the OUTPUT MODE explanations above. For details
on speaker placement in this mode see page 103.
of output mode: THROUGH, S =SB,
S=S & SB.
Press ENTER.
Your MULTI CH IN SELECT output set. Next, move on to
FUNCTION RENAME, if necessary.
If you want to change a setting before proceeding
Start over from step one.
use the 5∞ buttons to select the next
setup and press ENTER.
Go on to the next page.
use the 5∞ buttons to select RETURN
and press ENTER. Then use the 5∞
buttons to select EXIT and press
ENTER.
Advanced Setup
93
En