Setting Up The Main Unit; Assigning The Digital Inputs - Pioneer VSA-AX10I-S Operating Instructions Manual

7 Speaker terminals
1 Twist exposed wire
strands together
tightly.
10mm

3 3 3 3 3 Setting up the Main Unit

1 Connect the supplied AC power cord to the back of the main unit and plug the
other end into a wall outlet (don't use any other power cord than the one that
came with this amplifier).
2 Press the
POWER
3 Press the STANDBY/ON button to switch the amplifier ON.

4 4 4 4 4 Assigning the Digital Inputs

This is only necessary if you did not hook up your DVD player to DIGITAL IN 1 using a coaxial cable, as in
the diagram on p.11, but rather connected it to one of the optical digital inputs (for example, DIGITAL IN
4). The following example shows how to assign the DIGITAL IN 4 jack to DVD.
1
Amplifier
AMP
BASS/
TONE
ATREBLE
DVD/LD
VCR1
DISPLAY VIDEO
/DVR
DIMMER SELECT
VCR2
SPEAKER
STATUS
A/B
VCR3
SYSTEM
3
TV SETUP
4
System Setup
[ Auto Surround Setup ]
[1. Input Assign
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
5
1.Input Assign
[ 1.Digital-In ]
[ 2.Component Video In ]
[ 3.i.LINK Input ]
[Return]
2 Loosen speaker terminal
and insert exposed wire.
ON/OFF button to put the amplifier in ON mode.
2
1 Turn on the amplifier and your TV,
MAIN SUB REMOTE
SETUP
CD
2 Press the SUB button on the
CD-R/
TAPE1
EFFECT/
CH SEL.
TUNER
VIDEO
INPUT
LOUDNESS
ATT.
3 Press the SYSTEM SETUP button.
SAT
TAPE 2 SIGNAL
TV
MONITOR
SELECT
CONTROL
4 Looking at the on-screen display on
]
5 DIGITAL IN should be selected, if not
Quick Start Guide Part1
3 Tighten
terminal.
press AMP on the remote control.
AMPLIFIER remote control screen.
The SYSTEM SETUP menu appears on your TV (if it
doesn't, refer to page 11 to make sure you have
properly connected the amplifier to your TV).
your TV, use the 5∞ buttons to
select INPUT ASSIGN. Press the
ENTER button.
use the 5∞ buttons to select it.
Press the ENTER button.
13
En