Tape Playback; Tape Recording - Pioneer SA-6300 Operating Instructions Manual

EMPLOYING TAPE DECK
TAPE PLAYBACK
As shown in Fig. 7, the tape deck is connected to
TAPE PB jacks.
1. Set the TAPE MONITOR switch to ON.
2. Play tape on tape deck.
3. Adjust the VOLUME, BASS & TREBLE
controls for desired volume and tone.
NOTE:
Turning the TAPE MONITOR switch ON enables tape playback
whatever the setting of the FUNCTION switch.
TAPE DECK
Fig. 7
TAPE RECORDING
As shown in Fig. 8, the tape deck is connected to
TAPE REC jacks.
1. Set the FUNCTION switch to the source to be
recorded (PHONO, TUNER, etc.).
2. Operate the program source.
3. Adjust recording levels with the tape deck
- controls and proceed with recording.
NOTE:
The SA-6300 VOLUME, BASS & TREBLE controls have no effect
upon the signal at the TAPE REC jacks. The signal is recorded as it
comes from the program source and must be adjusted with the
controls on the tape deck.
TAPE DECK
Fig. 8
Monitoring Recording Conditions
If the tape deck is a 3-head type recording
conditions can be monitored through the speakers
or headphones by setting the TAPE MONITOR
switch to ON. Both recording and playback con-
nections must be made in this case.
TAPE DUPLICATION AND EDITING
By employing two tape decks, selected material
from a previously recorded tape can be edited onto
a second tape. A personal tape library can be
compiled in this manner.
1. Connect two tape decks as shown in Fig. 9.
2. Set the FUNCTION switch to AUX, and operate
the tape deck connected to the AUX jacks as the
program source.
3. Record the program onto the tape deck con-
nected to the TAPE terminals, controlling the
recording level by means of the controls on
that deck.
To monitor the recording while duplicating set
the TAPE MONITOR switch to ON.
TAPE DECK 2
(for recording)
TAPE DECK 1
(for playback)
i ig me
FUNCTIO
a (a
Fig. 9