Pioneer VSA-AX10I-S Operating Instructions Manual page 16

Quick Start Guide Part2
11
Check!!
FRONT
CENTER
SURROUND [ YES ]
SURR BACK [ YES
SUB WOOFER [ YES ]
[OK,Go Next]
[Retry]
[ERR Fix SP.]
[Return to Menu]
Auto Surround Setup
Now Analyzing
Surround Analysis
Speaker Systems
Channel Level
Speaker Distance
Acoustic Cal EQ
[Cancel]
Speaker Systems Check
" Normal Surround "
FRONT
CENTER
SURROUND
SURR BACK
SUB WOOFER [
[Next] ( Back/Next )
[Return]
memo
• Make sure the room environment follows the
guidelines displayed on the OSD during auto
setup. If the room environment is not optimal
for auto setup (too much ambient noise, echo
of the walls, obstacles blocking the speakers
from the microphone, etc.) the final settings
may be incorrect. Check for household
appliances (air conditioner, fridge, fan, etc.)
that may be affecting the environment and
switch them off if necessary.
• Some older TVs may interfere with the
operation of the mic. If this is the case turn
the TV off when doing the auto setup.
• Screens will turn off after three minutes and
the amplifier will automatically exit from the
setup process.
• If you leave CHECK!! or other error message
on the screen for three minutes, or you
choose CANCEL at anytime during the setup,
the settings made up to that point will be
cleared.
• After completing the Auto Surround Sound
Setup, ACOUSTIC CAL EQ ON (ALL CH ADJ)
is set automatically.
16
En
[ YES ]
[ YES ]
2 ]
X
•••
[OK]
[OK]
[OK]
[OK]
[ SMALL ]
[ SMALL ]
[ SMALL ]
[SMALL 2]
X
YES ]
11 Check the speaker settings on the
OSD
If they match your speaker configuration make sure
OK,GO NEXT is selected and press ENTER. The
system will output another series of test tones to
establish the proper channel level, speaker distance
and acoustic calibration EQ. Again, be prepared for
loud test tones. The test tones may take up to 5
minutes this time. After it has finished, you see the
SPEAKER SYSTEMS CHECK screen. If you want to
view the settings select NEXT and press ENTER
repeatedly. If not, simply go to step 13.
If they do not match the speaker configuration you
hooked up and you want to try again select RETRY
with 5∞ buttons and press ENTER. Follow the
instructions above from step 10.
If the speaker settings do not match the speaker
configuration you connected and you want to input
the settings manually select ERR=FIX SP with the
5∞ buttons, press ENTER and go to step 12.
If you see an ERR message in the right side column,
there may be a problem with the speaker connec-
tion. If selecting RETRY doesn't fix the problem, turn
off the power and check the speaker connections.
12 Use the ∞5 buttons to select a
speaker then the 2 3 buttons to
select the size of each speaker
individually. Use the ∞5 buttons to
select OK, GO NEXT and press
ENTER.
The system will output another series of test tones
to establish the proper channel level, speaker
distance and acoustic calibration EQ. Again, be
prepared for loud test tones.
After it has finished, you see the SPEAKER
SYSTEMS CHECK screen. If you want to view the
settings select NEXT and press ENTER repeatedly.
If not, simply go to the next step.
13 Select RETURN to go back to the
SYSTEM SETUP menu, then choose
EXIT to complete the auto surround
sound setup and return to normal
use.
You should now have settings that will give you good
surround sound. The MCACC indicator will also light
up to show that the surround sound settings are
complete.