Table of Contents
Advertisement
page 6.
BEFORE BEGINNING OPERATIONS
Set the controls and switches as follows: See page 6.
1. Set the POWER switch © to ON.
2. Set the BALANCE
control © to the center
position.
3. Set the TAPE 2 MONITOR switch © to off.
PLAYBACK PROCEDURES
1. Set the INPUT SELECTOR switch @ to the desired
playback source.
® For playback of a tape: Set to [TAPE 1/DAT].
* For reception of an AM/FM broadcast: Set to [TUNER].
© For playback of a compact disc: Set to [CD].
© For playback of a component connected to the LINE ter-
minals: Set to [LINE].
® For playback of a record: Set to [PHONO].
2. Operate the equipment to begin playback.
:
3. Adjust playback volume
with the VOLUME
control © on this unit.
RECORDING TAPES
1. Select the recording equipment with the INPUT
SELECTOR switch @.
2. Begin recording by operating the recording
equipment and cassette deck.
® Refer to the operating instructions for your cassette deck
for proper operating procedures.
8
<ARB7034>
COPY THE TAPE USING TWO DECKS
When two decks are used, you can record the sounds from
one deck onto the other.
Application exampies:
© To make a tape copy with contents identical to the original
tape.
© To edit a recording of an FM broadcast in order to cut out
unwanted commercials, recording only desired material
onto another tape.
1. Load the pre-recorded tape into the cassette deck
connected to the TAPE 1/DAT terminal and the
blank tape into the cassette deck connected to the
TAPE 2/MONITOR (ADPT) terminal.
2. Set INPUT SELECTOR switch @ to TAPE 1/DAT.
* Tape copying can only be performed in one direction,
from the cassette deck connected to the TAPE 1/DAT
terminal towards the cassette deck connected to the
TAPE 2/MONITOR (ADPT) terminal.
3. Operate the cassette decks to begin copying.
Set the cassette deck with the original (playback) tape to
the playback mode, and set the cassette deck with the
blank tape to the recording mode.
TO USE THE COMPONENT CONNECTED TO
THE TAPE 2/MONITOR (ADPT) TERMINALS:
(For an adaptor component)
By connecting a graphic equalizer, source sounds (from
records, tapes, AM/FM broadcasts, etc.) can be heard with
added sound and tone compensation.
1. Set the TAPE 2 MONITOR switch © to on.
2. Play back the source.
3. Operate the adaptor component.
(For a cassette deck}
A cassette deck connected here can be operated in the same
way (recording and playback) as a deck connected to the TAPE
T/DAT terminals.
On a cassette deck with the monitor function, (3-head deck }
sound can be concurrently heard while recording on tape.
This operation of checking the sound quality and recording
level is called "monitoring".
1. Set the TAPE 2 MONITOR switch © to on.
2. Operate the cassette deck to perform playback
(or recording).
Advertisement
Table of Contents
