Automatically Recording A Cd - Pioneer XR-A9700DV Operating Instruction

9 Using the Tape Deck
Tip
Sometimes when recording
from the AUX
(especially from a CD or MD
player), the signal level can be
too high for the tape deck to
record without distortion. If
this happens, reduce the
auxiliary signal level: switch the
system into standby then press
the button for about
DOLBY NR
three seconds until the display
shows . You should now
ATT ON
be able to record without
distortion. (When you select
the AUX mode, the display will
show .) To switch back
AUX ATT
to , follow the same
ATT OFF
procedure.
2 NR
7
TAPE I
ASES/COPY
48
En
5 Prepare the source for recording.
For example, load the CD or tune in the radio station. If you're recording a
inputs
disc, make sure that you've selected the correct disc and that it's stopped.
6 Press REC/STOP.
The deck starts recording.
7 Start the source playing (if necessary).
8 When you're ready to stop recording, press
REC/STOP again.

Automatically recording a CD

Auto Synchro Editing System, or ASES for short makes sure that when recording a
complete CD, a track isn't spread over two sides of a tape. If the tape runs out midway
through a CD track, the same track is automatically recorded from the beginning
again on the other side.
Note: this feature will not work with Video CD or DVD.
1 Prepare tape deck I for recording.
Load a blank cassette, wind on past the leader, and switch Dolby NR on or off
as required.
2 Load a CD.
Make sure that you've selected the correct disc and that it's stopped.
If you want to record the tracks in a different order, use the program play
feature —see page 35 for how to do this.
3 Press ASES/COPY to start recording.
4 If you want to stop recording before the end of
the CD, press 7 .
Note: ASES may not work correctly if the first side of the tape finishes at the same
time as a CD track ends. If this happens, stop the recording then resume on the other
side without ASES.