Copying Tapes; Improving Am Tape Recordings - Pioneer XR-A9700DV Operating Instruction

2 NR TAPE I/II
7
TAPE I
ASES/COPY
REC / STOP

Copying tapes

Here's how to copy a tape from TAPE II to TAPE I:
1 Press TAPE I/II.
2 Load a the tape you're recording from into
deck II.
Recording starts in the 3 direction, so take care over which way you load the
TAPE II
tape.
3 Prepare tape deck I for recording.
Load a blank cassette, wind on past the leader, and switch Dolby NR on or off
as required—for best results, switch on if the tape you're recording was
recorded using Dolby NR.
Note: It's not possible to switch Dolby NR on and off independently for each
deck.
4 Press ASES/COPY to start recording.
Recording starts in the 3 direction and continues onto the other side, unless
the erase-protect tab is broken on the TAPE I cassette.
5 If you want to stop recording before the end of
the tape is reached, press 7.

Improving AM tape recordings

Recording AM broadcasts on cassette tape can result in noisy recordings. If you
experience this, switch on the beat cut function:
1 Switch the power into standby.
2 Press REC/STOP for about 3 seconds.
Release when the display reads B.CUT 2.
Note: Switch beat cut off again by following the same procedure (the display reads
B.CUT 1 when off).
9 Using the Tape Deck
49
En