Speaker Setup Guide; Safety Precautions When Setting Up; Home Theater Sound Setup - Pioneer RCS-77H Operating Insructions

Speaker Setup Guide

Speaker Setup Guide

Safety precautions when setting up

When assembling the speakers, lay them down flat on
their side to avoid accidents or injury. Make sure to use a
stable surface when assembling, setting up, and placing
the speakers.
Caution
• Please don't use the any attachments with the front
speakers other than the brackets provided.
1 Attach the front speaker stand bases to the
stems using the screws provided.
Before securing the base to the stand, thread the speaker
wire through the holes provided on the base as shown
below. Then, once you have aligned the stem and base,
secure with the small screws at the points shown at right.
2 Attach the smaller non-skid pads to the base of
the center speaker. The four large non-skid pads are
for the receiver subwoofeer (as shown).
Use the supplied adhesive to attach 4 pads to the base of
each speaker.
Non-skid pads
(small) x 4
Non-skid pads
(large) x 4
Note
1 See About the listening modes on page 24 for more on using the different listening modes with each speaker setup.
6
En

Home theater sound setup

Depending on the size and characteristics of your room,
you can place your speakers in one of two ways using this
1
system:
• Standard surround 5-spot setup – This is a
standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
Surround
• Connect the speaker system.
Refer to Connecting up to connect the speakers properly.
Place them as shown in the diagram above for optimal
surround sound.
Center speaker
After placing your speakers, complete Channel level
setting on page 29 then refer to Speaker distance setting
on page 29 to complete your surround sound setup.
Receiver
subwoofer
Front
left
Center Receiver subwoofer
left
Listening position
Front
right
Surround
right