Additional information
Chapter 7
Additional information
Setting the sleep timer
The sleep timer switches off the receiver subwoofer after
a specified time so you can fall asleep without worrying
1
about it.
1
Press SHIFT+SYSTEM SETUP.
2
Hold SHIFT and use the
SLEEP then press SHIFT+ENTER.
3
Hold SHIFT and use the
option then press SHIFT+ENTER.
Choose between the following options:
• SLP ON – Switches off after about an hour
• SLP OFF – Cancels the sleep timer
After selecting SLP ON, you can select SLEEP again to
check how much time is left. Each line indicates
approximately 12 minutes (remaining):
S L P - - - - -
Dimming the display
You can choose to dim the display if you find it too bright.
1
Press SHIFT+SYSTEM SETUP.
2
Hold SHIFT and use the
DIMMER then press SHIFT+ENTER.
3
Hold SHIFT and use the
LIGHT or DARK then press SHIFT+ENTER.
Note
1 The display dims when the sleep timer is set. The DVD recorder does not automatically switch off with the sleep timer.
DTS CD setting
If you play a DTS-encoded CD, you will need to change
this setting to hear the decoded signal.
1
2
buttons to select
3
CD TYPE from the menu, then press SHIFT + ENTER.
buttons to select an
4
setting, then press SHIFT + ENTER.
Select from:
Resetting the system
Use this procedure to reset all system settings to the
factory default.
1
2
panel
buttons to select
The next time you switch on, all the system settings
should be reset.
buttons to select
Switch the system into standby.
Press SHIFT+SYSTEM SETUP.
Hold SHIFT and use the
Hold SHIFT and use the
• NORMAL – Use for playback of regular audio CDs.
Some DTS-encoded CDs will output noise when
played.
• DTS-CD – Use for playback of DTS-encoded CDs, but
note that there may be a slight loss of regular audio
CD playback quality.
Switch the system on.
Press SURROUND while holding down the front
STANDBY/ON button.
buttons to select
buttons to select a
07
33
En