Tuner; Error Messages; Glossary - Pioneer RCS-77H Operating Insructions

Additional information
Problem
Can't operate using the remote
control.

Tuner

Problem
Considerable noise in radio
broadcasts.
Auto tuning does not pick up
some stations.

Error Messages

Message Description
MUTING • An operation is prohibited because the sound is muted (press MUTE).
EEP ERROR • Contact your Pioneer authorized service center or your dealer for servicing.
EXIT • Appears when a menu is automatically exited after a set period of inactivity.
96K
• An operation is prohibited because the source is 96 kHz digital.
NO SPTYP
• Try switching the unit off then on again. If the error still appears, please
contact a Pioneer authorized service center or your dealer.

Glossary

Dolby Digital
A multi-channel audio encoding system
developed by Dolby Laboratories that enables far
more audio to be stored on a disc than PCM
encoding.
Dolby
A matrix decoding technology developed by
Pro Logic II Dolby Laboratories that expands any two-channel
source audio, such as CDs and TV broadcasts, to
a five-channel playback (left/center/right/left
surround/right surround), resulting in a surround
experience.
DTS
A multi-channel audio encoding system
developed by Digital Theater Systems that
enables far more audio to be stored on a disc
than PCM encoding.
Manufactured under license from Dolby
Laboratories."Dolby", "Pro Logic" and the double-D symbol
are trademarks of Dolby Laboratories.
Remedy
• Replace the batteries (Putting the batteries in the remote control on page 16).
• Operate within 7 m, 30° of the remote sensor (Using the remote control on page 16).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• For operating the DVD recorder, make sure that the control cable and at least one set of
audio cables are connected. (page 9)
Remedy
• Connect the AM antenna (refer to the Connecting up) and adjust the direction and
position for best reception. You may also connect an additional internal or external AM
antenna (refer to Connecting auxiliary components on page 31).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You
may also connect an outdoor FM antenna (see Connecting external antennas on page 32).
• Turn off other equipment that may be causing the noise or move it further away.
• The radio signal is weak. Auto tuning will only detect radio stations with a good signal.
For more sensitive tuning, connect an outdoor antenna.
"DTS" and "DTS Digital Surround" are registered
trademarks of Digital Theater Systems, Inc.
07
35
En