Speaker Setup Guide; Home Theater Sound Setup; Spot/4 Spot Speaker Layout; Spot/2 Spot Speaker Layout - Pioneer HTZ585DVD-AP Operating Instructions Manual

Dvd/cd receiver & speaker system
Hide thumbs Also See for HTZ585DVD-AP:
Table of Contents

Advertisement

01

Speaker Setup Guide

Chapter 1
Speaker Setup Guide

Home theater sound setup

Not applicable to the HTZ-FS30DVD model
Depending on the size and characteristics of
your room, you can place your speakers in one
of two ways using this system. For the speaker
configuration, see the Setup Guide.

5 spot/4 spot speaker layout

This is a standard multichannel surround sound
speaker setup for optimal 5.1 channel home
1
theater sound.

3 spot/2 spot speaker layout

This setup is ideal when rear surround speaker
placement isn't possible or you want to avoid
running long speaker cables in your listening
2
area.

Preparing the speakers

Preparation common to all models

Attaching non-skid pads
Attach the smaller non-skid pads to the
base of each of speakers. The four large non-
skid pads are for the subwoofer.
U
se the supplied adhesive to attach 3 or 4 pads to
the base (flat surface) of each speaker.
Note
1 The front left and right speaker should be about 1.8 m to 2.7 m apart.
2 The surround left and right speakers should be about 1.5 m apart.
6
En
Preparation only for the HTZ787DVD/
HTZ787DVD-AP
The layouts of the 5/4 spot speaker and 3/2 spot
speaker are the same:
Assembling the speaker stands
Attach the speaker stand bases to the
stems using the screws provided.
Once you have aligned the stem and base,
secure with the small screws at the points see
the Setup Guide. Note that the speaker should
face in the direction of the base of the isosceles
triangle.
CAUTION
• Be careful not to tighten screws
excessively.
• If excessive force is used to tighten screws,
the threads of screw and/or nut may be
damaged. Use a middle-sized manual
screwdriver during assembly.
• Do not use power screwdrivers or oversized
screwdrivers that may exert excessive force
on the screws and nuts.
• Confirm that no foreign matter is stuck to
the stand base or the tall speaker during
assembly.
• If the unit is assembled with foreign matter
stuck between the stand base and the tall
speaker the unit may not be assembled
securely, resulting in tipping or falling.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents