Registering A Unit - Panasonic KX-TG8011FX Operating Instructions Manual

TG8011-8021FX(e-e).book Page 30 Wednesday, August 20, 2008 9:50 AM
Programming
L According to your country selection in
step 3, the answering system
announcement language changes as
follows (KX-TG8021):
- "Other"
-
-
L After changing the unit's region
setting/resetting the base unit, w
flashes on the handset momentarily.
This is normal and the handset can be
used once w stops flashing.

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit.
Important:
L The additional handset model
recommended for use with this unit is
noted on page 5. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when "Auto" is selected on
base unit (page 31), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a "radio
cell".
30
Note:
L Calls are disconnected when the
handset moves from one radio cell to
another.
English
Registering a handset to a
Czech
base unit
Slovak
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
1
Handset:
K (middle soft key) i N i
M
2
{V}/{^}: "Registration" i M
2 times
3
{V}/{^}: Select a base unit number.
i M
L This number is used by the
handset as a reference only.
4
Base unit:
Proceed with the operation for your
model.
■ KX-TG8011/KX-TG8012
Press and hold {x} for about 5
seconds. (No registration tone)
■ KX-TG8021
Press and hold {x} for about 5
seconds, until the registration
tone sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
5
Handset:
Wait until "Enter Base PIN" is
displayed. i Enter the base unit
PIN (default: "0000"). i M