Table of Contents
Advertisement
Programming
Enhancing security for phone calls
You can increase the security of phone
conversations by setting this feature to
"Enhanced". When "Enhanced" is selected,
is displayed. The default setting is "Normal".
Handset / Base unit
1
M
N#729
2
MbN: Select the desired setting. a MOKN
3
Proceed with the operation for your unit.
Handset: M
N
Base unit: M
N
Note:
R If you set repeater mode to "On" (page 39):
– Security is set to "Normal" and
displayed.
– "Security" is not displayed in the display
menu (page 31).
R When enhanced security is enabled, sound may
cut in and out during conversations.
Changing the base unit PIN
Important:
R If you change the PIN (Personal Identification
Number), please make note of your new PIN.
The unit will not reveal the PIN to you. If you
forget your PIN, contact an authorised service
centre.
Handset / Base unit
1
M
N#132
2
Enter the current 4-digit base unit PIN (default:
"0000").
3
Enter the new 4-digit base unit PIN. a MOKN
4
MbN: "Yes" a MOKN
5
Proceed with the operation for your unit.
Handset: M
N
Base unit: M
N
38
Registering a unit
Operating additional units
Available for:
KX-TGF310BX/KX-TGF320BX/KX-TGF320JX/
KX-TGF322JX
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
R The additional handset model recommended for
use with this unit is noted on page 4. If another
handset model is used, certain operations may
is
not be available.
Registering a handset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit (for example,
displayed even when the handset is near the base
unit), re-register the handset.
1
Handset:
M
N#130
2
Base unit:
Press and hold M
R If all registered handsets start ringing, press
M
3
Handset:
MOKN a Wait until "Base PIN" is displayed.
a Enter the base unit PIN (default: "0000").
a MOKN
R If you forget your PIN, contact an authorised
service centre.
Deregistering a handset
A handset can cancel its own registration to the
base unit, or other handsets registered to the
same base unit. This allows the handset to end its
wireless connection with the system.
Handset / Base unit
1
M
N#131
R All handsets registered to the base unit are
displayed.
N for about 5 seconds.
N again to stop, then repeat this step.
is
Advertisement
Table of Contents
