Panasonic Workio DP-1520P Operating Instructions Manual page 12

Digital imaging systems
Hide thumbs Also See for Workio DP-1520P:
Table of Contents

Advertisement

Getting To Know Your Machine
Precautions
Ventilation
■ The machine should be installed in a well-ventilated area to minimize the ozone density in the air.
WARNING
This appliance is supplied with a moulded three pin mains plug for your safety and
convenience.
A 13 amp fuse is fitted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating
of 13 amps and that it is approved by ASTA or BSI to BS1362
Check for the ASTA mark
If the plug contains a removable fuse cover you must ensure that it is refitted when the
fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is
obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR
OFFICE THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND
DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS
INSERTED INTO ANY 13 AMP SOCKET.
If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
WARNING: THIS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following
code:
Green and Yellow : Earth
Blue
Brown
As the colours of the wires in the main lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the
plug which is marked by letter E or by the safety Earth symbol "
GREEN-AND-YELLOW.
The wire which is coloured BLUE must be connected
to the terminal in the plug which is marked with the
letter N or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal in
the plug which is marked with the letter L or coloured
RED.
How to replace the fuse.
Open the fuse compartment with a screwdriver and
replace the fuse.
12
For U.K.
or the BSI mark
: Neutral
: Live
on the body of the fuse.
" or coloured GREEN or

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workio dp-1820pWorkio dp-1820e

Table of Contents