Advanced Stayd Settings; Arming & Disarming; Regular Arming; Sleep Arming - Paradox K636 User Manual

Leaving the site without changing arm mode:
[ ] for 2 sec.
OFF
Press and hold the [
OFF

Advanced StayD Settings

Window Mode and Re-arm Delay
In a Stay-armed system: This mode allows you to open one exterior zone without triggering an alarm. To enter
Window mode, press [
OFF
exit delay, allowing you to open an exterior zone such as a window or a door. The system will only allow you to
open one zone as the exit delay will end after doing so. When you close the open zone (window, door, etc.) that
zone will re-arm.
When closing an exterior zone such as a window or door, a delay will start allowing you to close the zone
properly. The re-arm delay starts when you close the zone, and you must keep the zone closed for the entire
delay period for it to re-arm. This is especially useful for windows that stick thus reducing false alarms.

Live View Mode:

During an alarm, press the [
opening and closing of zones as they occur.
Arming & Disarming
Take full advantage of your system by familiarizing yourself with all the arming methods. If your system is not
partitioned (see Partitioning on page 19), everything is considered as belonging to Partition 1.
If you cannot arm because a zone is open, the system will enter in Bypass Programming. Enter the two
NOTE:
digit zone you wish to bypass and press [

Regular Arming

This method will arm all the zones in the selected partition. Please note that Regular arming can also be activated
using Auto-Arming (see Auto-Arming on page 12) or One-Touch Arming (see One-Touch Arming on page 12).
How do I Regular arm?
1 Close all zones in the desired partition.
2 Press [ ] + [
ARM USER CODE
3 If you have access to both partitions (see Partitioning on page 19): Press the key corresponding to the
desired partition ([1] or [2]). For both partitions, press the other key after the confirmation beep.

Sleep Arming

Similar to Stay arming, Sleep arming allows users to remain in a protected area, but provides a higher level of
protection. For example, in a two-story house, the perimeter is protected with Stay arming. With Sleep arming,
the perimeter as well as the main floor are protected (motion detectors, etc.), allowing you to roam the second
floor and sleeping quarters. Sleep zones are zones that are bypassed when Sleep arming. For example, when
you go to sleep at night, the entire premises except your bedroom is fully armed. Sleep arming can also be
activated using Auto-Arming (see Auto-Arming on page 12) or One-Touch Arming (see One-Touch Arming on
page 12).
How do I Sleep arm?
1 Close all zones in the desired partition (except Sleep zones).
2 Press the [ ] key.
SLEEP
3 Enter your [
USER CODE
4 If you have access to both partitions (see Partitioning on page 19): Press the key corresponding to the
desired partition, [1] or [2]. For both partitions, press the other key after the confirmation beep.
Esprit E55
] key for 2 seconds on a keypad to leave the site without changing arm mode.
], then your [
USER CODE
] key to view the movement. The zone lights on the keypad will show the
CLEAR
ENTER
].
].
]. All zones that can be opened flash. The system will start an
], or press [ ] to bypass all open zones.
ENTER
10