Table of Contents
Advertisement
Problem
You cannot register the handset in the
base unit.
The battery strength is not displayed
correctly.
"
" flashes or the unit beeps every
15 seconds.
You charged the batteries fully, but
"
" flashes.
The charge indicator (
goes out while charging.
The base unit has registered a maximum of
6 handsets or the handset has registered a
maximum of 4 base units.
A wrong base unit password was entered. Enter the
correct password.
There is interference from other electrical units.
Locate the handset and base unit away from them.
You must finish registration within 1 minute after the
ringer tone sounds, or programming will be cancelled
(p. 41).
Check that the battery type selection is correct
(p. 51)
Charge the batteries fully (p. 13).
Clean the charge contacts and charge again (p. 13).
Install new batteries (p. 51, 57).
) light never
This is normal.
00
01
02
03
04
Remedy
10
05
11
06
12
07
13
08
14
09
55
15
16
17
18
19
Advertisement
Table of Contents
