Advertisement
Factory Default Settings
Before configuring your, you need to know the following default settings.
Web Interface (Username and Password)
Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the password to log in, you may press the RESET button up to
6 seconds to restore the factory default settings.
Attention
Attention
LAN Device IP Settings
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site
PPPoE
DHCP server
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
IP address
Subnet Mask
DHCP server function
IP addresses for
distribution to PCs
Chapter 3: Basic Installation
LAN Port
192.168.1.254
255.255.255.0
Enabled
100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
WAN Port
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP,
but you have to set the
username and password first.
16
Advertisement
