Sharp R-1900M Operation Manual page 13

* Suppose you want to set Program Lock ON.
1 Press the Custom Setting pad
x 2
3 2 2 Enter 3, 2 for Program Lock ON.
3 Press the START pad to save the
4 Press the STOP/CLEAR pad to
NOTE : If you select Program Lock OFF, the LOCK indicator in
the display will disappear when you press the START pad.
Operation when Program Lock ON is set
KEY
Custom Setting Title
Operation
Selecting Memory
1
Input Method
Selecting Auto Start
2
Operation
3 Program Lock Setting
Audible Signal Sound
4
Volume Setting
Cooking Completion
5
Signal Setting
6 Memory Check
Counter Check/Clear
7
Air Intake Filter
8 Counter
Selecting Operation
9 in case of Magnetron
Failure
Multiplication Factors
x2/x3 for Double/Triple
Quantity
EXPRESS Express Defrost
DEFROST Setting
R-1900M [EN].indd Sec1:12 R-1900M [EN].indd Sec1:12
Procedure
twice within 2 seconds.
setting.
exit from the Custom Setting
Function.
When Program
Lock ON is set
no operation
no operation
operation
no operation
no operation
operation
check : operation
clear :
no operation
check, clear :
operation
set : no operation
no operation
check : operation
set : no operation
check : operation
set : no operation
4. Audible Signal Sound Volume Setting
The volume of the audible signal can be adjusted to High,
Medium, or Mute.
CH41 : High = Factory Setting
CH42 : Medium
CH43 : Mute
To set cooking completion signal volume
Press the CUSTOM SETTING pad twice within 2 seconds then
enter the numbers
4, 1 for High
4, 2 for Medium
4, 3 for Mute
Press the START pad to save setting and the STOP/CLEAR
pad to exit from the Custom Setting Function.
NOTE : Even when errors occur, your oven will not beep in
mute setting.
5. Cooking Completion Signal Setting
There is a choice of 4 different signals on your oven.
CH51 : 1 long beep = Factory setting
CH52 : Repeating long beeps
CH53 : 4 short beeps
CH54 : Repeating short beeps
To set the signal type
Press the CUSTOM SETTING pad twice within 2 seconds then
enter the numbers
5, 1 for 1 long beep
5, 2 for repeating long beeps
5, 3 for 4 short beeps
5, 4 for repeating short beeps
Press the START pad to save settings and the STOP/CLEAR
pad to exit from the Custom Setting Function.
6. Memory Check
Use this setting to check the programming for a certain
memory.
* Suppose you want to know the information programmed
into memory 1, programmed for 4 minutes at 60% for
the 1st stage and 2 minutes at 30% at the 2nd stage
programmed Dual Digit Input.
Procedure
6
x 2
1 Press the CUSTOM SETTING
pad twice within 2 seconds and
enter 6.
12
Display
NO. CHECK
9/29/08 1:36:33 PM 9/29/08 1:36:33 PM