Mounting The Homebase; Desk Mounting; Wall Mounting - Hand Held Products Dolphin 7900 User Manual

Mounting the HomeBase

Set the Dolphin HomeBase on a dry, stable surface, such as a desktop or workbench near an electrical outlet. Be sure to provide
enough workspace with good lighting for the user to view and operate the Dolphin terminal while it is in the HomeBase.
When choosing a location, bear in mind that:
• The mounting location must allow users easy access to the AUX Battery LED (see page 13-2).
• The serial, USB, and power jack face straight out of the rear panel. You will most likely want easy access to them in the future.

Desk Mounting

Dolphin charging/communication cradles have a DIN rail (7.5mm high X 35mm wide) slot on the bottom to allow for secure desk
attachment of the unit if desired.
Serial and USB port location (not in view)
Auxiliary
Battery
Well
DIN Rail
(7.5 X 35 mm)
1. Slide the DIN rail slot along the bottom panel.
2. Using the appropriate nuts and bolts, secure the DIN rail to the desk or flat surface.

Wall Mounting

A wall mount kit that contains a screws and a mounting bracket can be purchased separately. The bottom panel of the HomeBase
contains four rubber feet - one at each corner - that help keep it stable and secure when resting on a flat surface. Those rubber
feet should be removed with pliers before wall mounting the HomeBase.
1. Secure screws to the bottom panel by sliding them into the available slots.
13 - 10 Rev D Dolphin® 7900 Series User's Guide