About Tab; Using The Status Icon - Hand Held Products Dolphin 7900 User Manual

Field Description
Resets all the settings to default values
Defaults
Apply Applies changes. This button is active only when a change has been made on the tab.

About Tab

The About tab displays Version Number and time of build for Network Driver, Configuration Utility, and NIC Firmware.

Using the Status Icon

You access the 801.11b Settings by tapping the Status icon once on the Today screen
Menu Option
Wireless Radio On
Wireless Radio Off
Remove Status Icon
Wireless Network Status
Configuration
Advanced Configuration
Version Information
Note: The Status Icon changes to a crossed lock
for the WEP-On AP or a station.
Dolphin® 7900 Series User's Guide
• Always Enable for Power Save Mode,
• Automatic based on WEP setting for Authentication Algorithm, and
• Auto TX Preamble (for Preamble Mode).
Selecting This Option...
Turns on the radio. LED is on and the Link Icon displays with signal strength.
Turns off the radio. A pop-up window will ask for your confirmation. If confirmed, the LED
will be off and the Status icon will change color from green to red on the top without signal
strength displayed. The WLAN card/module will stop functioning.
Opens the Status tab; Status
Opens the Config tab; Config
Opens the Advanced tab;
Opens the About tab; About
as a warning that you may have entered a wrong key (WEP Key mismatch)
Removes the Status Icon from the bottom tray. A pop-
up window asks you to confirm. Click Yes to confirm, or
No to cancel.
If confirmed, the Status icon does not display in the
task tray, and you will need to go to Start > Programs
> 802.11b Settings in the future.
Tab, page 9-3.
Tab, page 9-4.
Advanced Tab, page 9-8.
Tab, page 9-9.
Rev D
. The following menu pops up:
9 - 9