Setup And Status Display; Settings; Basic Setting - Mitsubishi NZ2WL-US User Manual

5. Setup and Status Display

This chapter explains about setting items and status displays of this product. Always read Chapter 2
"Setup" and Chapter 3 "Connection to Devices and Setup Methods" for preparation before performing
setup or viewing the status. At the time of purchase, this product is configured as an access point.
This section describes how to setup this product and status displays using a web browser.

Settings

◆Basic setting

Host Name
■
Enter the host name of the product using 31 or less alphanumeric characters. Assigning a name to this
product allows easy identification on the network.
Factory default setting: (Not input)
DHCP Client
■
Enabling "DHCP client" makes this product available as a DHCP client.
Factory default setting: Disable
IP Address
■
Specify the IP address of the product. Make sure to perform this setting when not enabling the DHCP
client. When setting via a LAN using a browser running on a PC, the network address of the product
must be the same as the network address of the PC.
Factory default setting: (Specified on the housing sticker)
Subnet Mask
■
If using a subnet, specify the subnet mask.
If DHCP Client is set to "Enable", you can skip this setting.
Factory default setting: 255.0.0.0
Default Gateway
■
Specify the IP address of the router for the network to which the product belongs.
If DHCP Client is set to "Enable", you can skip this setting.
Factory default setting: 0.0.0.0
AP Composition
■
Sets the access point composition. Select "Compatible".
Normally, you do not have to change the default setting.
Factory default setting: Compatible
NZ2WL - xxx
5. Setup and Status Display
27