Hardware Installations - Verizon FiOS 9100VM User Manual

Verizon FiOS Router (Model 9100VM)

6.4 Hardware Installations

The following instructions explain how to install your Router using 10/100 Base-T Ethernet, Wireless or WAN
Ethernet connections. Before you begin, please read the following notes:
NOTE:
1. If your Ethernet card does not auto-negotiate, set it to half duplex. Refer to the Ethernet card manufacturer's
instructions for installing and configuring your Ethernet card.
2. If you are using Router in conjunction with an Ethernet Hub, Switch, or other VDSL2 device, refer to the
manufacturer's instructions for proper installation and configuration.
3. When using a Microfilter, confirm that the VDSL2 RJ-11 phone cable is connected to the VDSL2 port of the
DSL/HPN non-filtered jack.
4. It is recommended that you use a surge suppressor to protect equipment attached to the power supply. Use only
the power supply provided with your kit.
5. Additional Ethernet cables may be required depending on the installation method you are using. Ethernet cables
and filters can be purchased at your local computer hardware retailer.
6. The Router supports simultaneous use of 10/100 Base-T Ethernet, Wireless, and MoCA configurations. To use
this installation method, follow the instructions provided in sections 6.4.1 and 6.4.2, and 6.4.4.
The Router supports the following modes for WAN access, which are configurable through the Router's Web pages:
VDSL2, WAN Ethernet, and MoCA.
•
VDSL2 allows you to use the Router's VDSL2 port for WAN access. In this mode you should install the
Router according to the instructions in the following sections:
•
Section 6.4.1, Connecting the Router via 10/100 Base-T Ethernet
•
Section 6.4.2, Connecting the Router via Wireless
•
WAN Ethernet allows you to use the Router as an Ethernet Gateway (for example, to connect to another
VDSL2 device that provides WAN access). In this mode you should install the Router according to the
instructions in section 6.4.3, "Connecting the Router via WAN Ethernet."
•
MoCA allows you to connect the Router via a COAX interface such a set-top box. In this mode you should
install the Router according to the instructions in section 6.4.4, "Connecting the Router via COAX/Set-top
Box."
030-300239 Rev. A 13
User Guide
March 2008