Table of Contents
Advertisement
What to do if...
Certain problems are due to lack of simple maintenance
or oversights, which can be solved easily without calling
out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red pilot
light of button 8 blinks, one of the following alarm codes
appears on the display and some acoustic signals sound
every 20 seconds to indicate that the machine is not
working:
Problem
The washing machine does not start:
The machine does not fill:
The machine fills then empties im-
mediately:
22
•
•
•
Once the problem has been eliminated, press the button
8 to restart the programme. If after all checks, the problem
persists, contact your local Service Centre.
The door has not been closed. E40
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button 8 has not been
pressed.
• Please turn the selector dial and press the button 8 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The Child Safety Lock has been activated.
• Deactivate the Child Safety Lock.
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked. E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked. E10
• Clean the water inlet hose filter.
The door is not properly closed. E40
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «water drainage» section.
: problem with the water supply.
: problem with the water draining.
: door open.
Possible cause/Solution
Advertisement
Table of Contents
