What To Do If; Troubleshooting - Zanussi ZWT 71401 WA User Manual

Frost precaution
If the machine is exposed to temperatures be-
low 0°C, certain precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency emptying
hose and that of the inlet hose in a bowl
placed on the floor and let water drain out.
• Screw the water inlet hose back on and repo-
sition the emergency emptying hose after
having put the cap on again.
• When you intend to start the machine up
again, make sure that the room temperature is
above 0°C.
Emergency emptying out
If the water is not discharged, proceed as fol-
lows to empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled
down;

What to do if...

Certain problems are due to lack of simple
maintenance or oversights, which can be solved
easily without calling out an engineer. Before
contacting your local Service Centre, please
carry out the checks listed below.
During machine operation it is possible that the
red pilot light of button 8 blinks, one of the fol-
lowing alarm codes appears on the display and
some acoustic signals sound every 20 seconds
to indicate that the machine is not working:
www.zanussi.com
• open the pump door;
• place a bowl on the floor and place the end
of the emergency emptying hose into the
bowl. Remove its cap. The water should drain
by gravity into the bowl. When the bowl is full,
put the cap back on the hose. Empty the
bowl. Repeat the procedure until water stops
flowing out;
• clean the pump if necessary as previously de-
scribed;
• replace the emergency emptying hose in its
seat after having plugged it;
• screw the pump cover again and close the
door.
Important! Every time you drain the water
through the emergency emptying hose you must
pour 2 litres of water into the main wash
compartment of the detergent drawer and then
run the drain programme. This will activate the
ECO Valve device avoiding that part of the
detergent remains unused at next washing.
•
: problem with the water supply.
•
: problem with the water draining.
•
: door open.
Once the problem has been eliminated, press
the button 8 to restart the programme. If after all
checks, the problem persists, contact your local
Service Centre.
21