What To Do If - Zanussi ZKG 2125 User Manual

• Unscrew the hose from the machine. Keep a rug
nearby because some water may flow.
• Clean the filter in the valve with a stiff brush or with
the piece of cloth.
35°
• Screw the hose back to the machine and make sure
the connection is tight.
• Turn on the water tap.
Frost precaution
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.

What to do if...

Certain problems are due to lack of simple maintenance
or oversights, which can be solved easily without calling
out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red pilot
light of button 7 blinks, one of the following alarm codes
appears on the display and some acoustic signals sound
every 20 seconds to indicate that the machine is not
working:
18
• Place the end of the inlet hose in a bowl placed on the
floor, open the emergency emptying cap of the filter
and let water drain out.
• Refit the emergency emptying cap into the filter and
screw the water inlet hose back.
• When you intend to start the machine up again, make
sure that the room temperature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as follows to empty
out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• open the pump door;
• place a bowl on the floor. Remove the emergency emp-
tying cap from the filter. The water should drain by
gravity into the bowl. When the bowl is full, refit the
45°
emergency emptying cap into the filter. Empty the bowl.
Repeat the procedure until water stops flowing out;
• clean the pump if necessary as previously described;
• screw the pump cover again and close the door.
Important! Every time you drain the water through the
emergency emptying hose you must pour 2 litres of water
into the main wash compartment of the detergent drawer
and then run the drain programme. This will activate the
ECO Valve device avoiding that part of the detergent
remains unused at next washing.
•
: problem with the water supply.
•
: problem with the water draining.
•
: door open.
Once the problem has been eliminated, press the button
7 to restart the programme. If after all checks, the problem
persists, contact your local Service Centre.