Log In To The Configuration Home Page - CyberData RAL 9003 Operation Manual

Web Page Item

2.3.2 Log in to the Configuration Home Page

1. Open your browser to the Intercom IP address.
Note
Note
Note
Note
Operations Guide
Table 2-6. V2 Paging Amplifier Web Page Navigation (continued)
If the network does not have access to a DHCP server, the device will default to an IP
address of 10.10.10.10.
Make sure that the PC is on the same IP network as the Intercom.
You may also download CyberData's VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products.
CyberData's VoIP Discovery Utility program is available at the following website address:
http://www.cyberdata.net/support/voip/discovery_utility.html
The Intercom ships in DHCP mode. To get to the Home page, use the discovery utility to
scan for the device on the network and open your browser from there.
930323J
Installing the VoIP Indoor Intercom with Keypad
Description
Link to the Sensor Configuration page.
Link to the Multicast Configuration page.
Link to the Audio Configuration page.
Link to the Event Configuration page.
Link to the Autoprovisioning Configuration page.
Link to the Update Firmware page.
Log in to the Configuration Home Page
CyberData Corporation
17