Setting Values Of Tk-C676 Or Tk-C655 - JVC VR-609 Instructions Manual

■ Connection of RS-485 Control signal cable
When you install in a place with many noises,
please use a twisted-pair cable with a shield.
A shield cable should be connected to a GND
terminal.

3.3.2 Setting values of TK-C676 or TK-C655

Item
Switch 4
Switch 5
Switch 8
ID
・The functions can be used by this equipment are PAN/TILT/ZOOM/FOCUS/AUTO
FOCUS. (A setup of a home position, a preset position, etc. cannot be performed)
In addition, in order to perform a home position setup and a camera image setup in
advance, it is possible to use and set-up by remote controller of RM-P2580 grade.
Please read the Instructions of RM-P2580.
・About setting values of VR-609, please refer to 5.1.2 Camera details (P.42) and
5.1.3 Pan/Tilt Model Select (P.45).
If there are OFF/ON of a camera power supply when not performing a home position
!
setup, camera angle will return to the factory setting.
Home position : the camera angle that is set to after power on.
(Without setting home position, the camera angle is set to factory setting after power
on.)
VR-609
RS-485 Connector
+
-
GND
Value
ON
ON
Terminal camera is set to ON.
Other cameras are set to OFF.
Install ID value independently.
-- 26 --
Camera1
CONTROL Connector
C
RX+
D
RX-
Camera2
CONTROL Connector
C
RX+
D
RX-
Camera9
CONTROL Connector
C
RX+
D
RX-
VR-609