Setting Values Of Tk-C676 Or Tk-C655 - JVC VR-616U - 16 Channel Digital Video Recorder Instructions Manual

● Connection of RS-485 Control signal cable
VR-616
RS-485 Connector
When you install in a place with many noises,
please use a twisted-pair cable with a shield.
A shield cable should be connected to a GND
terminal.

3.3.2 Setting values of TK-C676 or TK-C655

Item
Switch 4
Switch 5
Switch 8
ID
● The functions can be used by this equipment are PAN/TILTE/ZOOM/FOCUS/AUTO
FOCUS. (A setup of a home position, a preset position, etc. cannot be performed) In
addition, in order to perform a home position setup and a camera image setup in
advance, it is possible to use and set-up by remote controler of RM-P2580 grade.
Please read the Instructions of RM-P2580.
● About setting values of VR-616, please refer to 5.1.2 Camera details and 5.1.3
Pan/Tilt Model Select.
● For information of other model, consult your nearest JVC dealer.
Please connect the Pan/Tilt camera of the same protocol (Camera Setup ->
!
Pan/Tilt Model Select -> Select Model).
+
-
GND
Value
ON
ON
Terminal equipment is set to ON.
Other equipments are set to OFF.
Install ID value independently.
Camera1 Connector
RX+
RX-
Camera2 Connector
RX+
RX-
Camera16 Connector
RX+
RX-
-- 27 --
JVC VR-616
C
D
C
D
C
D