Connecting The Ac Adapter - JVC KY-F75 Instructions Manual

2. Preparations (continued)

Connecting the AC adapter

It is possible to supply power to the KY-F75 from the computer via the IEEE1394 cable, but
when a motorized lens, etc., is used, the DC cable should be used to connect the KY-F75's [DC
IN] connector and the [TO CAMERA] connector on the AC adapter (AA-P700).
AA-P700
AC 100V
White marking
Connect the end with the
white marking to the AC
adapter
CAUTION
• Be sure to use the AA-P700 AC adapter.
Make sure that the power switch on the AA-P700 AC adapter is set to OFF before connections are
made. Making connections while the power is ON could result in damage to the KY-F75.
Connecting the DC power cable and attaching the filter clamp
Clamp filter
Plug
E16
AC adapter
(separately sold)
DC 12V=OUTPUT
VIDEO OUTPUT
S(Y/C) OUTPUT TO CAMERA
EITHER SEE INST-
OUTPUT RUCTION
MAX 1.25A MANUAL
TO CAMERA
connector
Ring
REMOTE
DC cable (2 m)
(separately sold)
After inserting the plug completely, tighten the se-
curing ring
To reduce the emission of unwanted radio waves,
make sure to attach the provided clamp filter as
shown in the figure on the left. Wind the cable once
around the clamp filter.
Attach the clamp filter as close as possible to the
KY-F75 as shown in the figure.
LENS
IEEE1394
DC IN
Functional
earth
POWER
SEE INSTRUCTION MANUAL
DC IN
connector
Clamp filter
(supplied)