Safety Information; Grounding Instructions - Maytag SAV2555AWW Installation Instructions Manual

Important Safety Information
About Ground Wires
In the event of an electrical short
circuit, a ground wire reduces the risk
of electric shock by providing an
escape wire for the electric current.
Standard accepted color coding for
ground wires is green or green with a
yellow stripe.
Grounding wires and wires colored like
grounding wires are NOT to be used
as current carrying conductors.
Save These
Instructions
Grounding Instructions
For safety, washer must be grounded. All washer power supply cords are
equipped with 3-prong grounding plug. Plug on cord must be plugged into
appropriate outlet that is properly installed and grounded in accordance with all
local codes and ordinances. Do not modify plug on washer cord. If plug will not
fit outlet, have qualified electrician install proper outlet.
WARNING
To avoid risk of personal injury or death due to electrical shock:
Observe all local codes and
ordinances.
• Disconnect electrical power to
unit before servicing.
• Ground appliance properly.
• Check with a qualified electrician
if you are not sure this appliance
is properly grounded.
• DO NOT ground to gas line.
• DO NOT ground to cold water
pipe if pipe is interrupted by
plastic, non-metallic gaskets, or
other insulating (non-conducting)
materials.
• DO NOT modify plug on power
cord. If plug does not fit electri-
cal outlet, have proper outlet
installed by qualified electrician.
• DO NOT have a fuse in the
neutral or ground circuit. A fuse
in the neutral or ground circuit
could result in an electrical
shock.
• DO NOT use an extension cord
with this appliance.
• DO NOT use an adapter plug
with this appliance.
• DO NOT pinch power cord.
Washer Dimensions
f
I
E
O
co
_O
co
m
rr
- 26.9" (68,3 cm)
E
o
v
co
53.5"
137,1 cm)
- 28" (71,1 cm)-
2"
(5,1cm)
J
Optional Kits
Kits are available at extra cost
through your Maytag dealer or
Maytag Customer Assistance at
1-800-688-9900 USA
1-800-688-2002 Canada
1-800-688-2080 TTY USA Only
Siphon Break Kit
For standpipe installation below 36"
(91.44 cm), install part #562P3.
Longer Water Inlet Hoses
8' (2.44 m) inlet hose, part #20617.
10' (3.05 m) inlet hose, part #20618.
Drain Hose Extension
Order this kit in two parts: the
coupler, part #406P3, and 1'
additional drain hose, part #20616.
Anchor Kit
To stop washer from moving on
uneven surfaces, install part
#155P3.
Adjustable leg Extension Kit
To level washer on extremely
uneven surfaces, install part
#566P3.