Maytag SAV2555AWW Installation Instructions Manual page 2

Top loading washer
Table of Contents

Advertisement

Available languages

Available languages

f
CONNECT
WATER
FILL HOSES TO
WASHER
Tightly push one flat rubber washer
into one end of each water fill hose
and attach this end of hose to
washer. HOT and COLD connec-
tions are identified by letters H and
C stamped into washer cabinet and
by HOT and COLD printed on water
fill hoses.
\
In most cases, hoses should cross
when attached to correct water tem-
perature faucet.
Tighten hose connections by hand
until snug, then another 1/4 turn
with pliers. DO NOT cross-thread or
over-tighten couplings.
;h rubber washer
into end of firth hose_
f
CONNECT
WATER
FILL HOSES TO
FAUCETS
Before connecting hoses to water
supply, turn on faucets and flush
lines for approximately
2 minutes to
remove foreign matter that could
clog filter screens in water mixing
valve or fill hoses.
Tightly push one screened filter
washer onto remaining end of each
water fill hose. Attach water hoses
\
to HOT and COLD faucets. BE
SURE HOT WATER HOSE IS
CONNECTED TO HOT WATER
FAUCET.
Tighten hose connections by hand
until snug, then another 1/4 turn
with pliers. DO NOT cross-thread or
over-tighten couplings.
Turn on water and check for leaks.
If leaks are found, retighten hose
couplings. Continue tightening and
rechecking until no leaks are found.
Faucets
Screen FHters
Hoses
J
f
SECURE
DRAIN HOSE
TO DRAIN
Remove drain hose from shipping
position on rear of washer by
unhooking hose from retainer
clamp. Use beaded tie-down
strap
to secure "hook" end of drain hose
to standpipe, wall inlet hoses, or
laundry tub (must hold at least 20
gallons).
IMPORTANT: To prevent siphoning,
do not place ribbed portion of drain
hose into standpipe. Avoid air-tight
seal around standpipe adapter.
For standpipe installation below 36"
(91.4 cm), install Siphon Break Kit
part #562P3.
For standpipe installation above 48"
(121.2 cm), install a check valve to
prevent water from flowing back into
washer. Available from local hard-
k,, ware store.
STANDPmPE
Standpipe
\_
adapter
_,_
(avoid
,_
air-tight
seaM)
36" (rain=)
from floor
_ _
Beaded
tie-down
_@
strap
TUB
72" (max,)
36" (rain=)
from floor
WALL UNiT
Beaded
tie-down
stra
36" (rain.)
T
from floor I
Beaded
tie=down
strap

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sav5910ewwSav4655ewqSav4655ewwSav2655awwSav5710aww

Table of Contents