Timer 2 - 10 Min Sailing Timer/Timer 3 - 6 Min Sailing Timer - Oregon Scientific OUTBREAKER RA201 User Manual

Notes:
a) If left idle for 30 sec, it will go back to TIMER 1.
b) To cancel the deletion of the LAP memory group, press FUNC
to go back to the LAP memory recall mode.
c) If no memory group records exists, "--" will be shown on the display.
Refer to Fig 5d to delete one LAP memory group for TIMER 1.
SET
SET
2 sec
Delete all LAP memory groups
1. Press SELECT in TIMER 1 mode after it is reset to 00:00:00 to
enter the LAP memory recall mode.
2. Press and hold FUNC for 2 seconds to enter the LAP memory
delete mode.
3. Press SELECT to select deleting all LAP memories.
4. Press and hold FUNC for 2 seconds to confirm the deletion of
all the LAP memories. "donE" followed by "--" will be shown
on the display after the deletion.
SELECT
SET
2 sec
Fig.5e
Fig.5d
5. Press FUNC to quit to TIMER 1.
Refer to Fig 5e to delete all LAP memory groups for TIMER 1.
Notes:
a) If left idle for 30 sec, it will go back to TIMER 1.
b) To cancel the deletion of the LAP memory groups, press FUNC
to go back to the LAP memory recall mode.
TIMER 2 – 10 MIN SAILING TIMER/TIMER 3 – 6 MIN
SAILING TIMER
RA201 has two pre-set sailing timers: TIMER 2: 10 min sailing
timer and TIMER 3: 6 min sailing timer. These sailing timers function
as a countdown timer but with countdown time fixed at 10 minutes
and 6 minutes and the timer minute can be increased or decreased
FUNC
while the timer is running.
1. Press FUNC from any display mode: sail-local pressure, sail-clock,
sail-altitude and sail-temperature to access to the sailing timer.
2. Press FUNC toggle to TIMER 1, TIMER 2 or TIMER 3.
3. Press ST/SP to start or stop the timer once either TIMER 2 or
TIMER 3 is selected.
4. Press +/- to increase or decrease the full counting minute while
the timer is running.
5. Press SP to stop the timer.
6. Press and hold SET for 2 seconds to reset the TIMER to the
initial pre-set value.
18