Recall Lap Memory For Timer 1; Delete The Lap Memory For Timer 1 - Oregon Scientific OUTBREAKER RA201 User Manual

c) At every second during the last ten seconds, there will be a short
beeping sound.
d) At the completion of the countdown, there will be a long beeping
sound for indication.
e) After completion of the countdown it will automatically activate
the stopwatch.
f) The maximum countdown time and stopwatch range will be
99:59:59.
g) The set time will be resumed after the timer is stopped and reset.
h) There are a total of 99 memory groups for the stopwatch; to be
used between a maximum of 99 memory groups or a maximum
of 99 lap memories or a combination of both.
i) While the stopwatch is working, every press on ST/SP button it
will be counted as one memory group and automatically stored
in the memory.
j) Once the LAP memories are used up, the chronometer still work
but without LAP memory function.
k) At the bottom of the display a running icon shows the status.
l) The latest memory group will be named as "M 1".

Recall LAP Memory for TIMER 1

1. Press SELECT in TIMER 1 mode after it is reset to 00:00:00 to
enter the LAP memory recall mode (recall can only be activated
when timer is not working).
2. Press +/- to toggle between memory groups. In the first display,
the date and time stamp will be shown for the starting time for
that corresponding memory group.
3. Press FUNC to recall the corresponding total (TTL) time.
4. Press +/- to scroll among the LAP memory.
5. Press FUNC to go back to TIMER 1.
Refer to Fig 5c to recall the LAP memory for TIMER 1.
Date & time stamp
+
SELECT
Note:
• If left idle for 30 sec, it will go back to TIMER 1.

Delete the LAP Memory for TIMER 1

The LAP memory group(s) can be deleted. It can either delete one
particular LAP memory group or delete all LAP memory groups.
Delete one LAP memory group
1. Press SELECT in TIMER 1 mode after it is reset to 00:00:00 to
enter the LAP memory recall mode.
2. Press +/- to select the particular memory group to be deleted.
3. Press and hold FUNC for 2 seconds in that particular group to
enter the LAP memory delete mode.
4. Press and hold FUNC for 2 seconds to confirm deletion of the
particular memory group. "donE" will be shown on the display
after the deletion.
5. Press FUNC twice to quit to TIMER 1.
17
Lap time for
Memory group's total time
- +
memory group
+ / -
FUNC
FUNC
Fig.5c
-